Vista Impact Construction
Home
Portfolio
Chat
Contact

Vista Impact

Wind Load Calculator

ASCE 7 Components & Cladding Wall Wind Pressure Calculator for accurate building design and engineering analysis

Professional Engineering Verification Required

This calculator is intended for preliminary design purposes only. All calculations and results must be verified by a licensed professional engineer before use in actual construction or building design. The results provided are estimates and should not be used as the sole basis for structural or design decisions.

Site Conditions & Building Information

Enter the basic site and building parameters for your wind load analysis.

1
Basic Parameters

2
Wind & Topographic Factors

3
Building Parameters

4
Analysis Parameters

Opening Details & Pressure Calculations

Specify dimensions for each opening to calculate wind pressure loads.

Zone 5 Corner Distance 'a' = 1.0 ft

MARK
WIDTH (in)
HEIGHT (in)
AREA (ft²)
ZONE
POSITIVE (psf)
NEGATIVE (psf)
-
---
---
-
---
---
-
---
---
-
---
---
-
---
---

i
Calculation Notes

  • • Area calculated as (Width × Height) / 144 for normal analysis
  • • For Impact Shutter Analysis: (Height × Height/3) / 144
  • • Maximum area for C&C method is 700 ft²

?
Zone Selection Guide

  • • Zone 5: Openings near building corners (within distance 'a')
  • • Zone 4: Openings along the midspan of the wall

Contact Us

4444 SW 71 Ave, Unit 103
Miami, FL 33155
+1 (305) 261-5058
[email protected]

Vista Impact Construction

Miami-based specialists in impact-resistant windows, doors, and remodeling for durable, secure Florida properties.

Follow Us

Licensed & Insured

General Contractor
#CGC1514809

Fully licensed and insured for your protection and peace of mind.

© 2025 Vista Impact Construction. All rights reserved.
Serving South Florida since 2007